Overhauls the DShot driver with per-timer BDShot selection, multi-timer
sequential capture, Extended DShot Telemetry (EDT), and AM32 ESC EEPROM
read/write via MAVLink. Expands ESC support from 8 to 12 channels.
BDShot:
- Per-timer BDShot protocol selection via actuator config UI
- Multi-timer sequential burst/capture on any DMA-capable timer
- Adaptive per-channel GCR bitstream decoding
- Per-channel online/offline detection with hysteresis
Extended DShot Telemetry (EDT):
- Temperature, voltage, current from BDShot frames (no serial wire)
- New DSHOT_BIDIR_EDT parameter
- EDT data merged with serial telemetry when both available
AM32 EEPROM:
- Read/write AM32 ESC settings via MAVLink ESC_EEPROM message
- ESCSettingsInterface abstraction for future ESC firmware types
- New DSHOT_ESC_TYPE parameter
Other changes:
- Per-motor pole count params DSHOT_MOT_POL1–12 (replaces MOT_POLE_COUNT)
- EscStatus/EscReport expanded to 12 ESCs with uint16 bitmasks
- Numerous bounds-check, overflow, and concurrency fixes
- Updated DShot documentation
* added vehicle command and support to remotely activate/deactivate the safety system (#26078)
* added print_status support for prearm safety status
* updated safety button to map to MAV_CMD_DO_SET_SAFETY_SWITCH_STATE = '5300'
* safety switch cmd: fixed incorrect catch-all and added commanded_state variable for easier reading
When operating fully autonomously (i.e., without manual control or a guaranteed link to the ground station), tuning a vehicle can be difficult since the current autotune process requires either RC input or a GCS command. For these scenarios, it it useful to be able to start autotune inside a mission.
ttechnick
Silvan
Marco Hauswirth
Jacob Dahl
Brandon W. Banks
mahima-yoga
Jacopo Panerati
bresch
Hamish Willee
GuillaumeLaine