New Crowdin translations - zh-CN (#26488)

Co-authored-by: Crowdin Bot <support+bot@crowdin.com>

docs/zh/companion_computer/ark_jetson_pab_carrier.md

@@ -12,19 +12,16 @@ The [ARK Jetson Pixhawk Autopilot Bus (PAB) Carrier](https://arkelectron.gitbook
 ## 产品规格
 
 - **Power Requirements**
-
   - 5V
   - 4A minimum (dependent on usage and peripherals)
 
 - **Additional Features**
-
   - Pixhawk Autopilot Bus (PAB) Form Factor ([PAB Standard](https://github.com/pixhawk/Pixhawk-Standards/blob/master/DS-010%20Pixhawk%20Autopilot%20Bus%20Standard.pdf))
   - MicroSD Slot
   - USA-built, NDAA compliant
   - Integrated 1W heater for sensor stability in extreme conditions
 
 - **Physical Details**
-
   - Weight:
     - Without Jetson and Flight Controller – 80g
     - With Jetson, no heatsink or Flight Controller – 108g

docs/zh/companion_computer/holybro_pixhawk_rpi_cm4_baseboard.md

@@ -170,7 +170,6 @@ To enable this MAVLink instance on the FC:
    ![Image of baseboard showing FC USB-C connector](../../assets/companion_computer/holybro_pixhawk_rpi_cm4_baseboard/baseboard_fc_usb_c.jpg)
 
 2. [Set the parameters](../advanced_config/parameters.md):
-
    - `MAV_1_CONFIG` = `102`
    - `MAV_1_MODE = 2`
    - `SER_TEL2_BAUD` = `921600`
@@ -184,7 +183,6 @@ On the RPi side:
 1. Connect to the RPi (using WiFi, a router, or a WiFi Dongle).
 
 2. Enable the RPi serial port by running `RPi-config`
-
    - Go to `3 Interface Options`, then `I6 Serial Port`.
      Then choose:
      - `login shell accessible over serial → No`

docs/zh/companion_computer/pixhawk_rpi.md

@@ -145,7 +145,6 @@ Enter the following commands (in sequence) a terminal to configure Ubuntu for RP
    ```
 
 3. Go to the **Interface Option** and then click **Serial Port**.
-
    - Select **No** to disable serial login shell.
    - Select **Yes** to enable the serial interface.
    - Click **Finish** and restart the RPi.
@@ -164,7 +163,6 @@ Enter the following commands (in sequence) a terminal to configure Ubuntu for RP
    ```
 
 6. Then save the file and restart the RPi.
-
    - In `nano` you can save the file using the following sequence of keyboard shortcuts: **ctrl+x**, **ctrl+y**, **Enter**.
 
 7. Check that the serial port is available.