enable gyro_calibration for CAN nodes

- allow saving initial gyro cal if very close to 0

boards/ark/can-flow/default.px4board

@@ -2,6 +2,7 @@ CONFIG_BOARD_TOOLCHAIN="arm-none-eabi"
 CONFIG_BOARD_ARCHITECTURE="cortex-m4"
 CONFIG_BOARD_ROMFSROOT="cannode"
 CONFIG_BOARD_CONSTRAINED_FLASH=y
+CONFIG_BOARD_NO_HELP=y
 CONFIG_BOARD_CONSTRAINED_MEMORY=y
 CONFIG_DRIVERS_BOOTLOADERS=y
 CONFIG_DRIVERS_DISTANCE_SENSOR_BROADCOM_AFBRS50=y
@@ -10,7 +11,14 @@ CONFIG_DRIVERS_IMU_INVENSENSE_ICM42688P=y
 CONFIG_DRIVERS_OPTICAL_FLOW_PAW3902=y
 CONFIG_BOARD_UAVCAN_INTERFACES=1
 CONFIG_DRIVERS_UAVCANNODE=y
+CONFIG_MODULES_GYRO_CALIBRATION=y
+CONFIG_MODULES_SENSORS=y
+# CONFIG_SENSORS_VEHICLE_AIR_DATA is not set
+# CONFIG_SENSORS_VEHICLE_GPS_POSITION is not set
+# CONFIG_SENSORS_VEHICLE_MAGNETOMETER is not set
 CONFIG_SYSTEMCMDS_PARAM=y
 CONFIG_SYSTEMCMDS_PERF=y
 CONFIG_SYSTEMCMDS_TOP=y
 CONFIG_SYSTEMCMDS_TOPIC_LISTENER=y
+CONFIG_SYSTEMCMDS_UORB=y
+CONFIG_SYSTEMCMDS_WORK_QUEUE=y

boards/ark/can-flow/init/rc.board_sensors

@@ -3,6 +3,8 @@
 # board sensors init
 #------------------------------------------------------------------------------
 
+param set-default IMU_GYRO_RATEMAX 1000
+
 # Internal SPI
 paw3902 -s start -Y 180