Docs/esp32c6: Rename esp32c6-devkit as esp32c6-devkitc

Documentation/platforms/risc-v/esp32c6/boards/esp32c6-devkitc/index.rst

@@ -82,7 +82,7 @@ Configurations
 
 All of the configurations presented below can be tested by running the following commands::
 
-    $ ./tools/configure.sh esp32c6-devkit:<config_name>
+    $ ./tools/configure.sh esp32c6-devkitc:<config_name>
     $ make flash ESPTOOL_PORT=/dev/ttyUSB0 -j
 
 Where <config_name> is the name of board configuration you want to use, i.e.: nsh, buttons, wifi...

Documentation/platforms/risc-v/esp32c6/index.rst

@@ -88,9 +88,9 @@ First make sure that ``esptool.py`` is installed.  This tool is used to convert
 the ELF to a compatible ESP32-C6 image and to flash the image into the board.
 It can be installed with: ``pip install esptool``.
 
-Configure the NuttX project: ``./tools/configure.sh esp32c6-devkit:nsh``
+Configure the NuttX project: ``./tools/configure.sh esp32c6-devkitc:nsh`` or
-Run ``make`` to build the project.  Note that the conversion mentioned above is
+``./tools/configure.sh esp32c6-devkitm:nsh``Run ``make`` to build the project.
-included in the build process.
+Note that the conversion mentioned above is included in the build process.
 The ``esptool.py`` command to flash all the binaries is::
 
      esptool.py --chip esp32c6 --port /dev/ttyUSBXX --baud 921600 write_flash 0x0 bootloader.bin 0x8000 partition-table.bin 0x10000 nuttx.bin